64
NS-24ER310NA17/NS-32DR310NA17/NS-48DR510NA17
www.insigniaproducts.com
Scanning for channels can take several minutes.
Now, you’re ready to watch broadcast TV! While you're watching, try the following:
• Press the UP and DOWN arrows to change channels.
• Press the LEFT arrow to display the channel list and then use the UP and DOWN arrows to select a channel to watch.
Or press REWIND or FAST FORWARD to jump through the channel list a page at a time.
• Press OK to display information about the current program.
• Press to switch to the previously tuned channel.
• Press to see options for picture and sound settings.
Using your TV
This section provides information on using the day-to-day features of your TV.
Status light
Your TV has a single status light on the front panel. It goes on and off and blinks in different ways depending on the
status of the TV, as shown in the following table:
Tip
Repeat the channel scan from time to time to make sure you are receiving all of the
latest channels. Broadcasters add and remove channels, move channels to different
parts of the spectrum, and change the power levels of their channels periodically.
Note
You’ll have to repeat the channel scan if you remove the Antenna TV tile from the
Home screen or perform a factory reset. To repeat the channel scan at any time, go to
Settings >TV inputs >Antenna TV > Scan again for channels > Start finding
channels. Your antenna reception and picture quality depend on the position of
your antenna and on your location relative to the antennas of broadcasters in your
area.
Note
If is not available on your remote control, you can use on the Roku App or the
Jump Back button on a universal remote. For more information, see Other devices on
page 91.
Remote control on page 19 has more information on using the remote control
buttons while watching TV.
TV condition Status indicator Meaning
On (screen is active) Off Screen is indicating that your TV is on.
Screensaver (screen is active,
except when the Picture
Mode is set to Low power.
Low power turns off the
backlight.)
Off Screen is indicating that your TV is on.
Off (no power) Off Your TV is not connected to power.
Off (standby) On
Your TV is connected to power and ready
to use.
Starting up from off state
Slow pulsing blink until
startup completes
Your TV is doing something.
On (receiving update from
USB)
Slow pulsing blink until
update completes
Your TV is doing something.
Remote control command
received
Dims on/off once Your TV has received your command.
Powering down to standby
mode
Slow pulsing blink until
the TV reaches standby
Your TV is doing something.
To Next Page
Loading...
