Insignia NS-28DD310NA15 - Using Component Video (Better)

16
NS-28DD310NA15 Insignia 28" LED TV/DVD Combo
www.insigniaproducts.com
Using component video (better)
1 Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a component video cable (not provided) to the VIDEO/Y, P
B, and PR jacks on the side of your TV and
the component video out jacks on the cable or satellite box.
4 Connect a 3.5mm RCA stereo audio cable (not provided) to the L and R AUDIO jacks on the side of your TV and
to the audio out jacks on the cable or satellite TV box.
5 Plug your TV’s power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
6 Press INPUT to open the INPUT SOURCE list.
7 Press
S or T to highlight Component/AV, then press ENTER.
Note
Cables are often color-coded to match color-coded jacks.
Notes
•The VIDEO/Y, P
B, and PR video jacks (used to connect a component
device) share the L and R AUDIO jacks with the VIDEO/Y jack (used to
connect an AV (composite video) device).
• When you connect the audio using the L and R AUDIO jacks, the audio
output is analog.
3.5mm RCA
stereo audio
cable
Cable or
satellite box
Component video cable
Side of TV
Component
video cable
connectors
RCA audio
cable
connectors
Analog
audio jacks
Component
video jacks
On your TV