17
www.insigniaproducts.com
Setup menu
Input menu
Navigating the menus
To navigate the on-screen menus:
1 Press MENU to open the on-screen menu.
2 Press or to highlight a menu, then press
ENTER to access the menu. You can select
Picture, Sound, Channel, Setup, or Input.
3 Press or to highlight an option, then press
ENTER to access the option.
4 Press or , or to highlight a setting or
adjust the option, then press ENTER to confirm.
5 Press RETURN to return to the previous menu or
EXIT to close the menu.
Selecting a channel
To select a channel:
• Press CH or CH to go to the next higher or
lower channel in the channel list.
• Press the number buttons to directly select a
channel. For example, if you want to view
channel 27, press 2, then press 7. Your TV goes
to the channel in a few seconds. If you want to
go to the channel quicker, enter the channel
number, then press ENTER.
• Press RECALL to go to the last viewed
channel.
• Press the number buttons for a main DTV
channel, press —, then press the number for a
DTV sub-channel to go to a digital
sub-channel (if available). For example, to go
to sub-channel 1 of main channel 7, press 7,
—, then 1.
Adjusting the volume
To adjust the volume:
• Press VOL – or VOL + to decrease or increase
the volume.
• Press MUTE to turn off the sound. Press
MUTE again (or press VOL– or VOL+) to
turn the sound back on.
Displaying additional information
To display additional information:
1 Press DISPLAY. Your TV displays status
information, such as the channel number, type
of sound, and picture and sound settings.
2 To close the display, press DISPLAY again or
wait about 10 seconds.
Channel
Setup
Input
Plug & Play
Language : English
Time
Game Mode : Off
V-Chip
Caption
Energy Saving : Off
Setup
Input
Source List
Edit Name
Notes
You can press the number buttons to go to a channel
that was skipped in the channel scanning.
TV #1
Fri, Dec 19 2:05 am
M. Spillane’s Mike Hammer
Bonocrunch
DTV Cable
13-1
Dolby Digital
480i 4:3 USA
NS-42P650A11-NS-50P650A11_09-1156_MAN_V1_English.book Page 17 Monday, January 18, 2010 11:01 AM