Insignia NS-BK2TBS8 - Installing and Setting Up Beer Kegs; Installing the Keg Coupler

14
NS-BK2TBS8/NS-BK2TBK8
www.insigniaproducts.com
Installing and setting up a beer keg
This kegerator accepts almost all brand name kegs. Here’s what will fit in
your kegerator:
*You can have a 1/4 (slim) and a 1/6, or a 1/4 (slim) and an 1/8 in your
kegerator at the same time.
Installing the keg coupler
1 Insert the sankey keg coupler into the neck of the beer keg and turn it
clockwise to lock it into position. Make sure that the washer is in the
connector on the top of the sankey keg coupler.
2 Insert the beer tube into the top of the sankey keg coupler, then
tighten the wing nut.
3 Repeat steps 1-2 if you have a second keg.
BARREL
SIZE
GALLONS
12 oz
GLASSES
(short, pony)
(slim)
HOW MANY
WILL FIT
Sankey keg coupler
Beer tube
Wing nut
Sankey keg coupler