Insignia NS-BK2TBS8 - Replacing Kegs; Replacing the CO2 Tank; Storing Your Kegerator

20
NS-BK2TBS8/NS-BK2TBK8
www.insigniaproducts.com
Replacing kegs
1 Unplug your kegerator from the wall outlet to turn it off.
2 Close the main valve on the CO
2
tank.
3 Close the shut-off valve on the CO
2
regulator.
4 Pull the black handle on the keg coupler and press it upward to close
the connection between the beer keg and the keg coupler.
5 Pull on the tap handle(s) to help drain beer from the lines.
6 Disconnect the beer line and CO
2
gas line from the keg coupler.
7 Put the beer line in a bucket to drain the remaining beer from the line.
8 Remove the beer keg(s).
9 Remove the keg coupler(s) from the keg(s).
10 Follow the steps in "Installing the keg coupler" on page 14 to insert a
new keg.
Replacing the CO
2
tank
1 Unplug your kegerator from the wall outlet to turn it off.
2 Close the main valve on the CO
2
tank.
3 Close the shut-off valve on the CO
2
regulator.
4 Disconnect the CO
2
gas line from the keg coupler.
5 Remove the CO
2
tank.
6 Follow the steps in "Installing the CO2 regulator and tank" on page 12
to insert a new tank.
Storing your kegerator
If you will be away from your kegerator for more than three weeks:
1 Unplug your kegerator from the wall outlet to turn it off.
2 Remove all kegs and all beverages.
3 Clean and dry the interior of the kegerator.
4 Leave the door open slightly to avoid possible formation of
condensation, mold, or odor.
Caution
Use extreme caution with children. The unit should not be
accessible to child's play.