9
3.3 Cubic Foot Compact Refrigerator
www.insigniaproducts.com
Setting the thermostat
1 The first time you turn the refrigerator on, adjust the thermostat to “4” and let
your refrigerator cool completely before putting food in. A full 24 hours is
recommended.
2 After it is fully cooled, test the temperature and adjust towards “1” to make it
less cool or towards “7” to make it cooler, as needed. The “4” setting should be
appropriate for home or office refrigerator use.
Reversing the door position
You will need: A 10 mm socket driver and a Phillips screw driver available.
• Make sure that your refrigerator is unplugged and empty.
• Have someone available to assist you in the process.
• Keep all of the parts you remove to reuse them later.
• Removing the door requires that the refrigerator be tilted backwards. Adjust
the two leveling feet to their highest postion.
Note: The refrigerator’s temperature ranges from 32° to 46.4°F (0° to 8°C).
Notes:
• Turning the thermostat to “0” stops the cooling cycle but does not shut off the
power to the refrigerator.
• If the refrigerator is unplugged or loses power, you must wait three to five minutes
before restarting it. If you attempt to restart before this time delay, the refrigerator
will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it one increment at a time.
Allow several hours for temperature to stabilize between adjustments.
Note: Do not lay the refrigerator completely flat as that could damage the coolant
system.
To Next Page
Loading...
Need help?
General
