14
www.insigniaproducts.com
12 Place the refrigerator door on the middle hinge and tape it into place, then
install the upper hinge and hinge cover on the upper left side of the
refrigerator, and the screw hole cover on the upper right side of the
refrigerator.
13 Untape the doors, then try both doors to make sure that they move freely.
Leveling your refrigerator
Your refrigerator must be level in order to function correctly. If your refrigerator is
not leveled during installation, the door may not close or seal correctly, causing
cooling, frost, or moisture problems.
• Rotate the leveling foot clockwise (to raise) your refrigerator or
counterclockwise (to lower).
Note: Make sure that the rubber gaskets make a good seal with the refrigerator all the way
around the doors before tightening the hinge screws.
Note: To make it easier to adjust the foot, have someone push against the top of your
refrigerator to tilt it slightly.
Screw hole
cover
Upper hinge
cover
Upper hinge
To Next Page
Loading...
Need help?
General