10
www.insigniaproducts.com
Installation instructions
Step 1: Check the door balance
1 Hold the top of the dishwasher firmly.
2 Open the door slowly, then release it. If the door drops, increase the spring tension. If the door closes, decrease the
spring tension.
3 Continue moving the spring pin until the door is balanced. Adjust both springs to the same tension.
Step 2: Remove the toekick
1 Lay the dishwasher on its back, then remove the two toekick screws with a Phillips screwdriver.
2 Remove the toekick.
CAUTION:
• Opening the door of your dishwasher before it is installed will cause it to tip forward. Do not open the door until you are ready to
install your dishwasher.
• If it is necessary to open the door, hold the top of the dishwasher securely with one hand and hold the door with the other hand.
To Next Page
Loading...
