8
www.insigniaproducts.com
Cabinet preparation and wire routing
• The wiring may enter the opening from either side, the rear, or the floor within the shaded area.
• The electrical connection is on the right front of the dishwasher.
• Drill a 1-1/2 in. (3.81 cm) maximum diameter hole to run the electrical cable through the wall of the cabinet.
• The hole must be free of sharp edges. If the cabinet wall is metal, the hole edge must be covered with a bushing
or rubber grommet.
• Cable direct connections may pass through the same hole as the drain hose and hot water line, but power cords
with plugs must pass through a separate hole.
Preparing the hot water line
• The water connection is on the left front of dishwasher.
• The hot water line may enter the opening from either side, the rear, or the floor within the shaded area.
• The hot water line may pass through the same hole as the electrical and drain hose. Or, you can drill an additional
1-1/2 in. (3.81 cm) maximum diameter hole for the hot water line.
• If a power cord with a plug is used, the hot water line may not pass through the same hole as the power cord.
24 in. (60.96 cm)
from wall
1-1/2 in. (3.81 cm)
diameter hole (max.)
2-1/2-3-1/2 in. (6.5-9.0 cm)
from cabinet
Ground
Black
White
1-1/2 in. (3.81 cm)
diameter hole (max.)
Shut-off valve
24 in. (60.96 cm) from wall
Hot
5-1/3 - 7-1/3 in.
(13.5-18.5 cm)
from cabinet
Cabinet face
3 in. (7.62 cm) from floor
To Next Page
Loading...
