Insignia NS-DWR3SS1 Installation Guide

4
www.insigniaproducts.com
Preparing to install your dishwasher
Parts supplied:
Tools needed:
Materials needed (kit purchased separately):
Wood screws (4)
Hose clamp
Top mounting clips (2)
Drain hose
Phillips screwdriver
Adjustable wrench
Level
Flashlight
1/4 in. and 5/16 in.
Nut driver
Tubing cutter
Flat blade
screwdriver
Safety glasses
Measuring tape
Hole saw set
Drill and bits
Gloves
New installations only
Bucket
90° Elbow, ferrule, and compression nut. (3/8
NPT external thread on one end. The other end
should be sized to fit the water supply line.
Three Wire nuts (UL listed)
(two included in kit)
Teflon thread
seal tape
Air gap (if
required)
Hand shut-off
valve
Screw-type hose clamps
Strain relief (for
electrical connections)
Electrical cable or power
cord (See Electrical
Requirements section)
Hot water line (min.
3/8 in. copper) kit
Waste tee for
house plumbing
(if applicable)
Coupler for extending
drain line (if applicable)
New installations only
Not included in kit
“T”connection
Garden hose
connection

Insignia NS-DWR3SS1 Specifications

General

Brand	Insignia
Model	NS-DWR3SS1
Category	Dishwasher
Language	English