18
NS-HMSB20
www.insigniaproducts.com
4 If you are mounting on drywall without studs or on concrete, install
wall anchors (included) into the holes you drilled.
5 Secure two screws (included) to the wall or wall anchors (if required).
The screws must protrude from the wall by about 5/32" (4 mm). Use a
9/16” (3.6 mm) self-tapping wood screw (or similar), 1-1/8" (28.5 mm)
in length. The screw head must be approximately 9/32" (7 mm).
6 Align the speaker hanging brackets with the screws, then hang the
soundbar on the screws.
WARNING: Improper installation can result in serious injury or damage to your
soundbar. If necessary, seek the assistance of a professional.
Approx.
5/32"
(4 mm)
Wall
11.4" (29 cm)
To Next Page
Loading...
