www.insigniaproducts.com
25
30" Square Fire Table - Black
Using your fire table
Lighting your fire table
1 Turn the control knob to the OFF position.
2 Turn on the valve on the gas tank.
3 Push in and turn the control knob to the HIGH position (counter-clockwise 90º).
4 Holding in the control knob, press the igniter button several times (you should hear a clicking sound) until the flame is
ignited. Release the control knob 10 seconds after ignition.
5 Turn the control knob to the LOW position and leave it there for five minutes before adjusting the flame to the level you
want.
6 If the burner flame goes out, turn off your fire table. Wait at least five minutes or more to let the gas dissipate, then
repeat steps 3 to 5.
WARNING: Be careful when attempting to manually ignite your fire table. Pressing the control knob for more than 10 seconds before
igniting the gas can cause a ball of flame upon ignition.
WARNING: Avoid inhaling fumes emitted from
your fire table’s first use. Smoke and odor from the burning of oils used in
manufacturing will appear. Both the smoke and odor dissipates after approximately 30 minutes. Your fire table should NOT produce
thick black smoke.
WARNING: Incorrect operation can cause injury or property damage. If the burner fails to remain lit, close all the valves and wait at
least five minutes before attempting to relight the burner.
Note: The burner may be noisy when initially turned on.
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
L
OW
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
LOW
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
LOW
To Next Page
Loading...
Need help?
General
