Insignia NS-R2001 User Manual

6
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
3 To listen to the speakers, press the SPEAKER A
or SPEAKER B button on the remote control or
the SPEAKER A/B button on the receiver to turn
the corresponding speakers on. SPK A, SPK B, or
SPK AB appears on the display and sound can
be heard from the speakers.
-OR-
To listen to the headphones, press the SPEAKER
A or SPEAKER B button on the remote control
or the SPEAKER A/B button on the receiver to
turn the corresponding speakers off. The
corresponding speaker indicator turns off, H
appears on the display, and sound can be heard
from the headphones.
4 Rotate the INPUT SELECTOR knob or press the
Input Selector button to select the input source,
then turn on and set up the device that has
been selected as the source to begin the
playback.
5 Turn the MASTER VOLUME dial or press the
VOLUME / buttons to adjust the sound
level.
-OR-
Press the MUTE button on the remote control to
turn the sound off. “MUTE” flashes on the
display. Press the MUTE button again to turn
the sound back on.
Adjusting the tone
Adjusting the tone lets you increase or decrease the
bass and/or treble tones of the music you are
listening to. When TON CTRL is shown on the
display, you can adjust the tone. When TON DIR is
shown on the display, the tone cannot be adjusted.
To adjust the tone:
1 Press the TONE button, then rotate the
UP/DOWN knob until TON CTRL appears on the
display.
1 Repeatedly press the TONE button to cycle
through the available tone modes
(BASS>TREBLE>TON CTRL). The tone mode is
displayed for three seconds.
OR
OR
OR
NS-R2001_10-1254_MAN_ENG.book Page 6 Friday, February 11, 2011 7:43 AM

Insignia NS-R2001 Specifications

General

Brand	Insignia
Model	NS-R2001
Category	Stereo Receiver
Language	English