Insignia NS-R2001 - Tone and Balance Adjustment; Fine-Tuning Tone Settings; Adjusting Sound Balance; Listening to the Radio

7
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
2 Within the tone mode, rotate the UP/DOWN
knob or press the TREBLE+/– or BASS+/–
buttons to adjust the tone.
3 Press the TONE DIRECT button on the remote
control to listen to a program without the tone
effect. TON DIR is displayed, DIR lights up, and
the sound bypasses the tone circuitry.
Adjusting the sound volume balance
To adjust the sound volume balance:
1 Press Balance. “BAL” and the balance level are
displayed for three seconds.
2 Within the balance mode, rotate the UP/DOWN
knob or press the BALANCE L/R buttons to
adjust the balance.
Listening to the radio
Auto tuning
To auto tune a radio station:
1 Repeatedly press BAND on the receiver or
TUNER on the remote control to select AM or
FM.
Notes
• If the tone display disappears, start again from
step 1.
• While displaying TON CTRL, if the UP/DOWN
knob is rotated, TON DIR will be displayed, and
vice versa.
• When pressing the TREBLE+/– or BASS+/–
buttons, you can skip step 1.
• Extreme settings at high volume may damage
your speakers.
Notes
• To cancel the tone direct function, press this
button again. TON CTRL is displayed and DIR
turns off.
OR
Note
• If the balance display disappears, start again
from step 1.
• When pressing the BALANCE L/R buttons, you
can skip step 1.
OR
OR
Band
Frequency
NS-R2001_10-1254_MAN_ENG.book Page 7 Friday, February 11, 2011 7:43 AM