www.insigniaproducts.com
16
9.2 Cu. Ft. Bottom-Mount Refrigerator
4 To speed the defrosting, you can:
• Place open containers with hot water inside the freezer compartment.
• Use a plastic or wooden ice shovel (like a spatula) to remove thick layers of ice or frost. Do not use a sharp utensil (like
a knife) because you may damage the freezer compartment.
5 When you finish defrosting, wipe the inside with a dry towel. If you need to clean the compartment, see Cleaning your
refrigerator on page 15.
6 Close the freezer compartment, plug your refrigerator into the power outlet, then put the food back into the freezer
compartment.
Replacing the LED light
Make sure that the replacement LED light strip is a 110 × 12 × 12mm, 12V light strip with a JST(XH) terminal.
1 Unplug your refrigerator.
2 Insert a flat-blade screwdriver into the gap in the bottom of the light cover, then carefully pry the cover away from the
housing. Pull the cover down and remove it.
3 Gently pull the LED light strip down to unplug it from the connector.
CAUTION: Make sure that you do not break the two tabs on the top of the cover as you remove the cover.