18
Insignia Soundbar with Wireless Subwoofer
www.insigniaproducts.com
Mounting your soundbar on a wall (optional)
You will need:
1 Select a location close to your TV and directly in front of the
viewing/listening position. For best sound quality, choose a location
where sound waves are not blocked by furniture or other obstacles.
2 If you are mounting your soundbar to drywall, use the stud finder to find
the studs and mark the locations.
3 Position the supplied wall mount template to the wall where you want to
mount the soundbar. Make sure that the template is level and note if it’s
aligned with a stud, then tape the template to the wall.
4 Drill two holes into the wall where the template indicates, then remove
the template.
5 If needed, install wall anchors (not included) into the holes you drilled,
using the instructions that came with your anchors.
Caution
Make sure that you use wall anchors that are suitable
to your wall type if you need to mount the soundbar
to drywall, concrete, or similar wall type.
Notes
• If you have drilled into a stud, wall anchors are
not required.
• If you cannot drill into wall studs and must drill
into drywall, concrete, or another type of wall,
wall anchors are required. See the instructions
that came with your wall anchors to determine
the drill bit size.
Drill a hole here Drill a hole here
HOLD THE LEVEL TO THE TOP EDGE OF THIS TEMPLATE
Wall mount template
Locate/Position holes onto studs behind
drywall when possible, -or use anchors for
mounting
Warning: Improper installation can result in serious injury or
damage to your soundbar.
If necessary, seek the assistance of a professional.
Scale: 1/1
Center Line
Center Line Center Line
Determine where you would like to mount
the soundbar. The center line of the template
should match the center of the TV.
Note: If you are mounting to drywall, use a
studfinder to locate studs. A wall anchor is not
needed if you are attaching to a stud.
Hold this template in the location you want,
and use a level to level it, then tape it to the
wall.
Drill two holes at the indicated points.
Wall
Remove the template from the wall.
You must use suitable wall anchors (not
supplied) if you cannot mount the soundbar to
available wall studs.
Wall
Anchor
Fasten two screws (not supplied) to the wall.
The screw heads should protrude from the wall
approximately 1/4 in. (6 to 8 mm). The screw
width must be about 3/16 in. and the screw
head about .3 in. (7.6 mm) to 3/8 in. (9.5 mm).
1/4 in.
(6 to 8 mm)
Wall
TOOLS NEEDED
Screws (2)
#10 × 1 ½ in. (3.8 cm)
wood screw (or similar)
Wall
anchors (2)
Align the speaker hanging brackets with the
screws, then hang the soundbar on the screws.
Wall
Soundbar
Wall mounting template
Level
Stud finder
(optional for wood
stud installation)
Drill and
drill bit
Hammer
Screwdriver
Tape measure
Tap e
Screws (2) - #10 x 1-1/2 in
(3.8 cm) wood screw (or similar)
Wall anchors (2)
NS-SB515_15-0527_MAN_V3_ENG.fm Page 18 Friday, July 24, 2015 10:21 AM
To Next Page
Loading...
