10
NS-STR514
www.insigniaproducts.com
Using your receiver
Listening to audio on your receiver
1 Turn on the audio input device.
2 Press the ON/STANDBY button on the receiver
or the remote control to turn the receiver on.
The STANDBY indicator is off. Press again to put
the receiver into standby mode and the
STANDBY indicator lights red.
3 Press the INPUT button on the receiver or press
one of the input buttons on the remote control
for the input source you want. Each time you
press the button on the receiver, the display
changes to reflect the input selected.
4 Start playback on the device you selected.
5 Press SPEAKER A or SPEAKER B on the remote
control. SPK A, SPK B, SPK AB, or SPK OFF
appears on the display and sound is heard from
the speakers.
6 Turn the VOLUME dial on the receiver or press
VOLUME +/– on the remote control to adjust
the sound level.
-OR-
Press MUTE on the remote control to turn the
sound off. “MUTE” flashes on the display. Press
MUTE again to turn the sound back on.
7 If you connected a video device, such as a DVD
or Blu-ray player:
a) Select that device's input on the TV.
b) Turn your TV speakers off if you only want
the audio to come from your receiver.
Adjusting the tone
Adjusting the tone lets you increase or decrease the
bass and/or treble tones of the music you are
listening to.
• On the remote control, press the TREBLE+/– or
BASS+/– buttons.
• The tone level can be adjusted within the
range of –10 to +10 dB.
Adjusting the sound balance
• Press BALANCE L or BALANCE R on the remote to
adjust the balance between the left and right
speakers.
Tips
The following settings are stored in memory before
the receiver is turned off:
• INPUT settings
• Preset stations.
If the electricity fails or the AC power cord is
unplugged for more than a week, your memory is
cleared.
Caution
Extreme settings at high volume may damage your
speakers.
NS-STR514_16-0462_MAN_V2_ENG.book Page 10 Monday, November 21, 2016 12:48 PM
To Next Page
Loading...
Need help?
General
