EasyManuals Logo

Inspire ignite User Manual

Inspire ignite
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
PAIRING INSTRUCTIONS
Put the Ignite device into pairing mode as detailed below
Ignite Wired
Press and hold 'CH MODE' and 'BOOST CH' keys
together on the Room Thermostat until C5 is
displayed.
Ignite Wireless / LITE (March 2021 onwards)
Long press BOTH buons on the Receiver until '1 and
WiFi' lights flash slowly.
Using the LEFT buon, cycle through the menu until
'CH' flashes.
Press the RIGHT buon, 'CH' will rapidly flash.
Ignite Wireless 4 channel / LITE 4 channel
(March 2021 onwards)
Long press BOTH buons on the Receiver until '1 and
WiFi' lights flash slowly.
Using the LEFT buon, cycle through the menu until
the required heating zone number flashes (1-4).
Press the RIGHT buon, this heating zone number will
now rapidly flash.
Ignite Wireless (March 2021 and earlier)
Sho press the pairing (middle) buon on the Relay
Module, this will make all three lights flash green.
Then press the CH buon, The CH buon will now
flash green.
7
TESTING THE SYSTEM
Ideally, the sma Sensor should be positioned at a height of
1.0 - 1.5 meters and in a high traffic area.
Hold the Sma Sensor in your desired location.
Press and hold /\ arrow buon for 5 seconds. The Ignite
Sma Sensor will enter into a signal strength mode.
A sweeping LED will be displayed whilst the signal detection in
in progress.
If a signal is detected, the strength will be measured from 1-5
lighting LEDs accordingly. to work effectively, the signal should
be a minimum of two LEDs.
If the unit has not been paired, two outside LEDs will rapidly
flash. Please return to pairing instructions on previous page
and follow the appropriate steps to pair the Sma Sensor
Sma Sensor
Ensuring the Inspire leaf logo is at the top, press and hold \/
buon for 5 seconds. All 5 LED's will slowly flash to indicate
unit is in pairing mode.
Upon successful pairing, the centre LED on the Sma Sensor
will rapidly flash.
If pairing fails, the two outside LED's will rapidly flash. Please
try the pairing procedure again.
8

Other manuals for Inspire ignite

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Inspire ignite and is the answer not in the manual?

Inspire ignite Specifications

General IconGeneral
BrandInspire
Modelignite
CategoryThermostat
LanguageEnglish

Related product manuals