22 English Inspire Sleep Remote
If you are having trouble positioning the sleep remote:
Note: These steps turn therapy off.
1. Make sure the audio tones are on. (For instructions on
turning audio tones on and off, refer to page 19.)
2. Press the Therapy Off button ( ).
3. Position the sleep remote directly over your generator
and against your body. The buttons should face away
from your body (Figure 12).
4. Adjust the sleep remote position until the rear surface of
the remote, opposite the Therapy On button ( ), is
directly over your generator (Figure 5).
5. Wait until the sleep remote produces a tone or 10
seconds pass.
6. Remove the sleep remote from your body and review the
sleep remote lights to confirm that the change was
communicated to your generator.
Notes:
• If the sleep remote produces three rapid beeps, or the
change you want is not indicated by the sleep remote
lights, then try communicating with your generator again.
• The sleep remote communicates one change at a time. If
you press an incorrect button, wait for 10 seconds until
the sleep remote stops attempting to communicate with
the generator, and then press the correct button.
To Next Page
Loading...
Need help?
General
