Inspire SLEEP REMOTE User Manual

Inspire Sleep Remote English 21
To position your sleep remote for communication with
your generator:
1. Press a button. The therapy status light flashes to
indicate the change is in progress.
2. Position the sleep remote over your generator and
against your body. The buttons should face away from
your body (Figure 12).
Figure 12. Correct positioning of sleep remote over generator
3. Adjust the sleep remote position until the Therapy On
button ( ) is directly over your generator.
4. Slowly adjust the sleep remote position until the sleep
remote produces a tone or 10 seconds pass.
5. Remove the sleep remote from your body and review the
sleep remote lights to confirm that the change was
communicated to your generator.
Note: If the sleep remote produces three rapid beeps, or the
change you want is not indicated by the sleep remote lights,
then try communicating with your generator again.

Inspire SLEEP REMOTE Specifications

General

Brand	Inspire
Model	SLEEP REMOTE
Category	Medical Equipment
Language	English