Inspire SLEEP REMOTE - Page 59

Inspire Sleep Remote English 45
You do not hear
audio tones, but
the sleep remote
is working.
• Audio tones are
turned off.
• Turn audio tones on (refer to
page 19).
You hear three
beeps after
pressing the
Increase ( ) or
Decrease button
().
• The stimulation
strength is at the
upper or lower
limit.
• Confirm that the current
stimulation strength does not
work for you. Contact your
doctor to change the
stimulation strength limits.
You hear three
beeps several
seconds after
pressing a
button.
• A setting in your
generator has
changed.
• Communication
with your
generator was
not successful.
• Review current therapy
settings and try your change
again.
Stimulation is
uncomfortable.
1. Press the Therapy Off button
().
2. Reduce the stimulation
strength by pressing the
Decrease button ( ), and
then holding the sleep
remote over your generator.
3. Press the Therapy On button
( ) to test the stimulation
strength. Decrease
stimulation further if
necessary (refer to page 29).
If this happens: Possible
causes:
Try these steps: