46 English Inspire Sleep Remote
Stimulation is too
strong.
• Decrease stimulation (refer to
page 29).
Stimulation is not
strong enough.
• Increase stimulation (refer to
page 28).
You feel that a
change took
place after you
pressed a button,
but the sleep
remote lights did
not change.
• The sleep
remote was too
far from the
generator. (The
generator may
have received
the sleep remote
signal, but the
sleep remote did
not receive the
generator
confirmation
signal.)
• Hold the sleep remote closer
to your generator. Review the
positioning instructions on
page 20. Try your change
again.
• An electronic
device interfered
with
communication
between your
sleep remote
and generator.
• Turn off or move away from
other electronic devices. Try
your change again.
If this happens: Possible
causes:
Try these steps:
To Next Page
Loading...
