Inspur NF5280M5 - User Manual

Inspur Server User Manual
NF5280M5

Summary

Warnings and Safety Information

Critical Safety Warnings

Highlights essential safety precautions to prevent potential dangers, injury, or death.

Safety Instructions

Server Operations and Procedures

Server Power Up and Down Procedures

Server Setup and Environment

Optimizing the Server Environment

Temperature and Power Requirements

Electrical Grounding and Rack Warnings

Server Installation and Operating System Setup

Hardware Options Installation Guide

Processor Installation Procedure

Detailed steps for installing or replacing the server's processor.

Memory Module Installation

Guides on selecting and installing memory modules, including population guidelines.

Hot-plug HDD Installation

Redundant Hot-plug Power Supply Installation

Expansion Board Installation

BIOS Setup and Configuration

Common BIOS Operations and Interface Login

UEFI and Legacy Mode Switching

HDD Information and RAID Configuration

BMC Network Parameter Configuration

Guides on viewing and setting BMC network parameters like IPv4 and IPv6.

BIOS Parameter Description - Main and Advanced

Processor and Memory Configuration

Server Management (Server Mgmt) Settings

Details settings for server management, including BMC network and user configuration.

Firmware Update Procedures

BMC Settings and Management

IPMI 2.0 Features and Commands

Details IPMI 2.0 features, channel assignments, and supported commands.

Management Web GUI Navigation

Guides users on accessing and navigating the Management Web GUI.

SNMP Protocol Configuration

Explains the Simple Network Management Protocol (SNMP) for network management.

Smash-Lite CLI Usage

Details how to use the Smash-Lite Command Line Interface for BMC management.

System Information and Health Status

Provides information and health status for CPU, Memory, Storage, and Network.

BMC Logs: System Event, Audit, and Blackbox

Explains how to access and interpret system event, audit, and blackbox logs.

Event Alerting and Notification Settings

Guides on configuring SNMP Trap and SMTP Email alerts for system events.

System Diagnostics and Troubleshooting Tools

Details diagnostic tools like BIOS Post Code and Screen Capture.

BMC Watchdog and Self-Recovery Mechanisms

Explains BMC watchdog functions and self-recovery capabilities.

LED Indicators for System Health

BMC Network Configuration and Bonding

Covers BMC network interface settings, bonding, and NCSI configuration.

User Management and Privilege Levels

Details user management, privilege levels for IPMI, Web, and CLI access.

Protocols and Ports Configuration

Lists supported protocols and ports for BMC services.

Time and NTP Synchronization Settings

BIOS and BMC Interaction

Describes the interaction between BIOS and BMC for system management.

BIOS Setup Options and Boot Configuration

Storage Controller Information

Provides information on supported RAID and SAS controllers.

Server Control Features

Covers server location (UID LED) and virtual power button controls.

Power Supply and Consumption Management

Details power supply redundancy, active standby, power peak, and limits.

Fan Speed Control (FSC) and Firmware Updates

Explains fan speed control and procedures for updating BMC and BIOS firmware.

Serial Over LAN (SOL) and Console Redirection

Virtual Media Redirection

Redfish Management Standard

Troubleshooting Common Server Faults

Hardware Problems and Solutions

Software Installation and System Issues

Electrostatic Discharge (ESD) Prevention

Preventing Electrostatic Discharge Damage

Grounding Methods for ESD Protection

Product Warranty Information

Warranty Service Overview and Terms

Warranty Exclusions and Limitations

Inspur NF5280M5 Specifications

General

Product Name	Inspur NF5280M5
Category	Server
Form Factor	2U
Processor	Intel Xeon Scalable processors
DIMM Slots	24 DIMM slots
Memory	DDR4
Drive Support	SAS, SATA, NVMe
PCIe Slots	Up to 7 x PCIe 3.0 slots
Network Interface	Dual 10GbE
Power Supply	Redundant
Management	IPMI 2.0
Storage	Up to 10 x 2.5" or 4 x 3.5" drives