Insta360 Flow - Unfold and Fold

3
Unfold and Fold
Unfold: Hold Flow around the Pan Arm (where the battery is located), then gently pull the handle
down.
ON
Notes:
• Attach the phone to Flow via the magnetic phone clamp before unfolding.
• Once Flow is turned on, it will detect whether a phone is connected within 30 seconds. If no
phone is detected, it will enter standby mode (same if phone is removed while using Flow).
Fold: Hold the Pan Arm and pull the handle up to close and power off Flow. Then, remove the
phone.
OFF