6
Get started
7
Get started
3. Press Delay Start again to toggle to the minutes field and adjust
the delay time minutes.
4. Delay Start begins automatically and the timer counts down.
5. When Delay Start ends, the Smart Program begins, and the display
indicates On.
Delay Start is not available with the Sauté or Yogurt Smart Programs.
Reset Smart Programs to original settings
Reset Individual Smart Programs
With the cooker in Standby mode, press and hold one Smart
Program button until the cooker returns to Standby and
shows OFF.
The Smart Program’s pressure level, cooking time and temperature are restored to the
factory default setting.
Reset All Smart Programs
With the cooker in Standby mode, press and hold Cancel until the
cooker beeps.
All Smart Program pressure levels, cooking times and temperatures are restored
to the factory default setting.
INITIAL SET UP
Clean before use
1. Wash the inner cooking pot with hot water and soap. Rinse and use
a soft cloth to dry the outside. Or you can wash the inner cooking
pot in the dishwasher.
2. Wipe the heating element inside the cooker base with a soft cloth
to ensure there are no stray packaging particles.
Setting up the condensation collector
The condensation collector sits at the back of the cooker base and
accumulates overflow moisture from the condensation rim. It should be
installed before cooking, then emptied and rinsed out after each use.
Remove the condensation collector
Pull the condensation collector away from the cooker base; do not
pull down.
Note the tabs on the cooker base and the grooves on the condensation collector.
Install the condensation collector
Align the grooves on the condensation collector with the tabs on
the back of the cooker base and slide the condensation collector
into place.
Plug in cord (3QT and 6QT models)
When you’re ready to use your Instant Pot Duo, plug the electrical cord
into the power socket on the back of the unit.
Note: the 8QT model has an electrical cord that is always connected to the unit.