EasyManua.ls Logo

Instant Pot Duo Plus Series - User Manual

Instant Pot Duo Plus Series
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DUO
TM
PLUS
3, 5.7 and 8 Litres
Multi-Use Pressure Cookers
User Manual
Important Safeguards
Product Specications
Initial Set-up
Product, Parts and Accessories
Smart Programme Settings
Cleaning Before First Use
Overview of Pressure
Control Features
Initial Test Run (Water Test)
Cooking with the Duo Plus
Pressure Cooking Timetable
Grain-to-Water Ratios
Care, Cleaning and Storage
Troubleshooting
Warranty
Contact Information

Questions and Answers

  • F
    feliciajenkinsAug 17, 2025
    Why is steam leaking from the side of my Instant Pot Duo Plus lid?
    • J
      johntaylorAug 17, 2025
      Steam may leak from the side of the Instant Pot Electric Pressure Cooker lid due to several reasons: * There is no sealing ring in the lid: Install a sealing ring. * The sealing ring is damaged or not installed properly: Replace the sealing ring. * Food debris is attached to the sealing ring: Remove the sealing ring and clean it thoroughly. * The lid is not closed properly: Open, then close the lid. * The sealing ring rack is warped or off-center: Remove the sealing ring from the lid, then check the sealing ring rack for bends or warps. Contact Customer Care. * The inner pot rim may be misshapen: Check for deformation and contact Customer Care.
  • J
    Jacob CoffeyAug 20, 2025
    What to do if I have difficulty opening the lid of my Instant Pot Duo Plus?
    • J
      Jessica RodgersAug 20, 2025
      If you have difficulty opening the lid of your Instant Pot Electric Pressure Cooker: * The contents may be under pressure. To avoid scalding injury, do NOT attempt to force the lid open. * There may be pressure inside the multicooker. Release pressure according to the recipe. Only open the lid after the float valve has dropped down. * The float valve may be stuck in the popped-up position due to food debris or residue. Release pressure completely, then tap the float valve gently with a long utensil. * Open the lid cautiously, then thoroughly clean the float valve, surrounding area, and lid before next use.
  • T
    Thomas SmithAug 23, 2025
    Why is it difficult to close the lid on my Instant Pot Duo Plus Electric Pressure Cooker?
    • D
      Debra MccoyAug 23, 2025
      It may be difficult to close the lid on your Instant Pot Electric Pressure Cooker because: * The sealing ring is not properly installed. Reposition the sealing ring, ensuring it is snug behind the sealing ring rack. * The float valve is in the popped-up position. Gently press the float valve downward with a long utensil. * The contents in the multicooker are still hot. Hold the quick release switch in the Vent position as you lower the lid onto the multicooker base slowly, allowing heat to dissipate.
  • B
    Bridget ThompsonAug 26, 2025
    Why doesn't the float valve rise on my Instant Pot Duo Plus Electric Pressure Cooker?
    • P
      Patricia RodriguezAug 26, 2025
      The float valve on your Instant Pot Electric Pressure Cooker may not rise because: * There is food debris on the float valve or float valve silicone cap. Remove the float valve from the lid and clean it thoroughly. Perform the Initial test run to check for function and record your findings. Contact Customer Care. * There is too little liquid in the inner pot. Check for scorching on the bottom of the inner pot. Add thin, water-based liquid to the inner pot according to its size. (6 Qt: 1 ½ cups (375 mL / ~12 oz); 8 Qt: 2 cups (500 mL / ~16 oz))
  • M
    Martha Randall MDAug 28, 2025
    What to do if the inner pot is stuck to the lid of my Instant Pot Duo Plus after opening?
    • J
      Jacqueline LeeAug 28, 2025
      If the inner pot is stuck to the lid of your Instant Pot Electric Pressure Cooker after opening, it may be caused by the cooling of the inner pot creating suction, causing the inner pot to adhere to the lid. To release the vacuum, move the quick release switch to the Vent position.
  • R
    Russell HillAug 30, 2025
    Why does my Instant Pot Electric Pressure Cooker make occasional clicking or light cracking sounds?
    • M
      Maria LoweAug 30, 2025
      The occasional clicking or light cracking sound from your Instant Pot Electric Pressure Cooker is normal. It is the sound of power switching and expanding pressure board when changing temperatures; no action is needed.
  • R
    Richard GarciaSep 5, 2025
    Why is steam gushing from the steam release valve on my Instant Pot Electric Pressure Cooker when sealed?
    • J
      Jay JohnsonSep 5, 2025
      If steam gushes from the steam release valve of your Instant Pot Electric Pressure Cooker when the quick release button is in the Seal position, it could be due to: * Not enough liquid in the inner pot. Add thin, water-based liquid to the inner pot according to its size: 3 Litre: 250 mL 5.7 Litre: 375 mL 8 Litre: 500 mL. * Pressure sensor control failure. Contact Customer Care. * Steam release valve not seated properly. Flick quick release button to ensure it is in the Seal position.
  • J
    Jonathan ColemanSep 8, 2025
    What to do if the inner pot is stuck to the lid of my Instant Pot Electric Pressure Cooker?
    • T
      tiffanymyersSep 8, 2025
      If the inner pot is stuck to the lid when you open your Instant Pot Electric Pressure Cooker, it's likely due to suction created by cooling. To release the vacuum, press the quick release button down until it clicks into the Vent position.
  • T
    tsmithSep 12, 2025
    Why is there a small steam leak from the steam release valve during cooking with my Instant Pot Electric Pressure Cooker?
    • C
      Cassandra GentrySep 12, 2025
      A small amount of steam leaking or hissing from the steam release valve of your Instant Pot Electric Pressure Cooker during the cook cycle usually means the quick release button is not fully in the Seal position. Flick the quick release button to ensure it is in the Seal position.
  • D
    Daniel FernandezSep 13, 2025
    Why is the display blank on my Instant Pot Duo Plus Electric Pressure Cooker?
    • L
      Lisa HickmanSep 13, 2025
      If the display of your Instant Pot Electric Pressure Cooker remains blank after connecting the power lead, it could be due to a bad power connection or a blown fuse. Inspect the power lead for damage. If damage is noticed, contact Customer Care. Check the outlet to ensure it is powered. If the outlet is fine, the cooker's electrical fuse may have blown, in which case you should contact Customer Care.

Summary

Important Safeguards

Special Lead Set Instructions

Instructions for safe use of the power supply lead to reduce hazards.

Product Specifications

Details on models, wattage, voltage, dimensions, and weight.

Initial Setup

Product, Parts and Accessories

Top of Lid Components

Identifies components on the top surface of the pressure cooker lid.

Bottom of Lid Components

Identifies components on the underside of the pressure cooker lid.

Inner Pot

Cooker Base

Accessories

Control Panel

Time Display and Pressure Field

Explains the function of the time display and pressure level indicators.

Control Options and Indicators

Describes Less/Normal/More options and LED indicators.

Smart Programme Settings

Smart Programme Settings Details

How to adjust and save settings for cooking programs.

Smart Programmes List

Lists all available pressure and non-pressure cooking programs.

Status Icons Explanation

Explains the meaning of different status icons.

Adjust and Save Cooking Parameters

Control Panel Operations

Cancel, Standby, and Sound Management

Managing program cancellation, standby mode, and sound alerts.

Temperature Scale and Delay Start

Switching temperature units and setting a delayed start timer.

Keep Warm and Reset Functions

Automatic Keep Warm and Reheating

Managing automatic keep warm and reheating food.

Resetting Programme Settings

Restoring program settings to factory defaults.

Cleaning Before First Use

Overview of Pressure Control Features

Lid and Valve Operation

How to open/close the lid, use the quick release button and steam valve.

Component Maintenance

Information on the anti-block shield, sealing ring, and float valve.

Condensation Collector

How to install and use the condensation collector.

Initial Test Run (Water Test)

Cooking with the Duo Plus

Introduction to Pressure Cooking

Explains the pressure cooking process and its stages.

Depressurizing the Cooker (Venting Methods)

Describes natural and quick release venting methods.

Using Pressure Cooking Smart Programmes

Pressure Cooking Settings

Table of default settings for various pressure cooking programs.

Pressure Cooking Tips

Advice and suggestions for using pressure cooking programs.

Grain-to-Water Ratios

Using Non-Pressure Cooking Smart Programmes

Slow Cook and Sauté Programs

Instructions for using Slow Cook and Sauté smart programs.

Yogurt and Sous Vide Programs

Instructions for Yogurt and Sous Vide smart programs.

Sous Vide Cooking Guidelines

Recommended temperatures and times for sous vide cooking.

Care, Cleaning and Storage

Troubleshooting

Lid Operation Issues

Solutions for difficulty closing or opening the lid.

Steam Leaks and Inner Pot Problems

Troubleshooting steam leaks and stuck inner pots.

Float Valve and Display Errors

Resolving issues with the float valve and display errors.

Error Codes and Operational Sounds

Explanations and solutions for error codes and sounds.

Warranty

Limited Warranty Details

Details the warranty period, coverage, and limitations.

Warranty Limitations and Exclusions

Outlines what the warranty does and does not cover.

Contact Information

Warranty Service and Registration

How to register the product and obtain warranty service.

Recycling Information

Guidelines for responsible disposal of electronic waste.

Instant Pot Duo Plus Series Specifications

General IconGeneral
ModelDuo Plus Series
Voltage120V~ 60Hz
Warranty1-year limited warranty
FunctionsPressure Cook, Slow Cook, Rice Cook, Steamer, Sauté, Yogurt Maker, Warmer
Capacity6 Quart
Power1000 Watts
MaterialStainless Steel
DisplayLCD Display
Safety FeaturesOverheat Protection, Safety Lock
Pressure LevelsHigh and Low
Dimensions13.4 x 12.2 x 12.5 inches (6 Quart)
Weight11.8 lbs

Related product manuals