To Next PageTo Next PageWhy is my rice half cooked in the Instant Pot IP-DUO5-ENW?
If your rice is half-cooked or too hard in the Instant Pot Electric Pressure Cooker, adjust the dry-rice and water ratio according to the recipe. After the cooking cycle completes, let the cover remain on for 5 more minutes.
Why is my rice too soft when using Instant Pot IP-DUO5-ENW Electric Pressure Cooker?
If your rice is too soft, it's likely because you're using too much water. Adjust the dry-rice and water ratio according to the recipe.
Why is steam leaking from the side of my Instant Pot IP-DUO5-ENW lid?
Steam leaking from the side of the Instant Pot Electric Pressure Cooker lid can occur if the sealing ring is missing, damaged, or has food debris attached to it. Ensure the sealing ring is installed correctly, replace it if damaged, and clean it thoroughly. Also, make sure the lid is closed properly.
What to do if the Instant Pot IP-DUO5-ENW Electric Pressure Cooker lid is hard to open?
If the Instant Pot Electric Pressure Cooker lid is difficult to open, it could be due to pressure still inside the cooker. Use the steam release handle to fully release the pressure before attempting to open the lid. Alternatively, the float valve might be stuck; gently press it down with a pen or chopstick.
Why is the display blank on my Instant Pot IP-DUO5-ENW Electric Pressure Cooker?
If the display of your Instant Pot Electric Pressure Cooker remains blank after connecting the power cord, check the power cord to ensure it is properly connected and that the power outlet is active. If the issue persists, contact support online.
What to do if steam comes out from exhaust valve non-stop from my Instant Pot IP-DUO5-ENW Electric Pressure Cooker?
If steam is continuously coming out of the exhaust valve, it's likely because the steam release handle isn't in the sealing position. Turn the release handle to the sealing position. If the issue persists, the pressure control may have failed.
Why is it difficult to open the lid of my Instant Pot IP-DUO5-ENW?
It's difficult to open the lid because either pressure exists inside the cooker, or the float valve is stuck. To address this: * Use the steam release handle to reduce the internal pressure, and then open the lid after the pressure is completely released. * If the float valve is stuck, press it lightly with a pen or chopstick.
What to do if steam leaks from the side of the lid of my Instant Pot IP-DUO5-ENW Electric Pressure Cooker?
Steam leaking from the lid usually means: * There's no sealing ring installed, so you should install it. * The sealing ring is damaged, so you should replace it. * There's food debris on the sealing ring, so you should clean it. * The lid isn't closed properly, so open and close it again.
Why does my Instant Pot Electric Pressure Cooker display flash 'Lid'?
If the display on your Instant Pot Electric Pressure Cooker flashes 'Lid', it means the lid isn't in the correct position for the selected program. Close the lid for pressure cooking or open it for sautéing.
Why is steam leaking from the float valve on my Instant Pot IP-DUO5-ENW Electric Pressure Cooker?
If steam leaks from the float valve of your Instant Pot Electric Pressure Cooker for more than 2 minutes, it could be due to food debris on the float valve silicone seal. Clean the seal. If the silicone ring is worn out, replace it.
General| Model | IP-DUO5-ENW |
|---|---|
| Type | Electric Pressure Cooker |
| Capacity | 5 quarts |
| Material | Stainless Steel |
| Power | 1000 watts |
| Functions | Pressure Cooker, Slow Cooker, Rice Cooker, Steamer, Sauté, Yogurt Maker |
| Voltage | 120V |
| Dimensions | 12.2 x 12.5 inches |
| Pressure Settings | High and Low |
| Safety Features | Overheat Protection, Safe Locking Lid |
