Instant Pot IP-LUX60 V3 User Manual

19
Problem Possible Reason Soluon
1
Dicult to close the lid
Sealing ring not installed
properly
Posion the sealing ring well
Float valve in the popped-up
posion
Slightly press the oat valve
downward
2
Dicult to open the lid
Pressure exists inside the
cooker
Posion the pressure release
valve to the venng posion
to reduce the internal pres-
sure. Open the lid aer the
pressure is completely
released.
Float valve stuck at the
popped-up posion
Press the oat valve lightly
with a pen or chopsck.
3
Steam leaks from the
side of the lid
No sealing ring Install the sealing ring
Sealing ring damaged Replace the sealing ring
Food debris aached to the
sealing ring
Clean the sealing ring
Lid not closed properly Open then close the lid again
4
Steam leaks from oat
valve for over 2
minutes
Food debris on the oat valve
silicone seal
Clean the oat valve silicone
seal
Float valve silicone ring worn-
out
Replace the oat valve silicone
ring
5
Float valve unable to
rise
Too lile food or water in
inner pot
Add water according to the
recipe
Float valve obstructed by the
lid locking pin
Close the lid completely, see
“Cooking Preparaon” secon
Steam comes out from
the pressure release
valve non-stop
Pressure release handle not
in sealing posion
Turn the pressure release
handle to the sealing posion
6
6
Pressure control fails Contact support online
7
7
Display ashes “Lid”
Lid is not in the correct posi-
on for the selected program
Close the lid for pressure
cooking or open the lid for
sautéing
Troubleshoong Table

Instant Pot IP-LUX60 V3 Specifications

General

Brand	Instant Pot
Model	IP-LUX60 V3
Category	Electric Pressure Cooker
Language	English