What to do if the inner pot is stuck to the lid when my Instant Electric Pressure Cooker is opened?
If the inner pot sticks to the lid when you open your Instant Electric Pressure Cooker, it's likely due to suction created as the inner pot cools. To prevent this, select quick release to release all the pressure from the inner pot.
Why is steam leaking from the side of my Instant Kitchen Appliances lid?
Steam leaking from the side of the Instant Kitchen Appliances lid can occur for several reasons. Make sure there is a sealing ring in the lid. If there is one, it may be damaged or improperly installed, in which case you should replace it. Food debris attached to the sealing ring can also cause leaks; remove the sealing ring and clean it thoroughly. Ensure the lid is closed properly. If the sealing ring rack is warped or off-center, remove the sealing ring and check the rack for bends or warps, and contact Consumer Care. A misshapen cooking pot rim can also cause this issue; check for deformation and contact Consumer Care.
What to do if steam gushes from the steam release vent on my Instant POT PRO PLUS?
If steam gushes from the steam release vent when the Steam Release switch is in the Seal position on your Instant Kitchen Appliances, it could be due to not enough liquid in the cooking pot. Add thin, water-based liquid to the cooking pot: 1 1/2 cups (12 oz / 375 mL). Also, it could be a pressure sensor control failure. In this case contact Consumer Care.
Is minor steam leaking from my Instant POT PRO PLUS normal?
Minor steam leaking or hissing from the steam release vent during the cooking cycle of your Instant Kitchen Appliances is normal. The cooker is regulating excess pressure, so no action is required.
Why is steam leaking from the side of the Instant POT PRO PLUS Kitchen Appliances lid?
Steam leaking from the side of the lid can be due to several reasons: * There is no sealing ring in the lid. In this case, install a sealing ring. * The sealing ring is damaged or not installed properly. Replace the sealing ring. * There is food debris on the sealing ring. Remove the sealing ring and clean it thoroughly. * The lid is not closed properly. Open, then close the lid. * The sealing ring rack is warped or off-center. Remove the sealing ring from the lid, then check the sealing ring rack for bends or warps. Contact Customer Care. * The cooking pot rim may be misshapen. Check for deformation and contact Customer Care.
Why is steam gushing from the steam release valve during pressure cooking cycle of my Instant POT PRO PLUS?
Steam gushing from the steam release valve during the pressure cooking cycle can happen because: * There is not enough liquid in the cooking pot. Add thin, water-based liquid to the cooking pot according to its size. * There is a pressure sensor control failure. Contact Customer Care.
Why does my Instant Electric Pressure Cooker make occasional clicking or light cracking sounds?
Occasional clicking or light cracking sounds from your Instant Electric Pressure Cooker are normal. This is due to the sound of power switching, or the pressure board expanding as temperatures change; no action is needed.
What to do if the display remains blank on my Instant Electric Pressure Cooker after connecting the power cord?
If the display on your Instant Electric Pressure Cooker remains blank after plugging it in, first check the outlet to ensure it's powered. Then, inspect the power cord for any signs of damage. If you notice damage or the outlet isn't working, contact Customer Care. The multiooker’s electrical fuse may have blown. Contact Customer Care.
Why can't my Instant Electric Pressure Cooker build pressure?
If your Instant Electric Pressure Cooker isn't building pressure, it could be due to food debris on the float valve or its silicone cap. Also, there might not be enough liquid in the inner pot, or the float valve silicone cap could be damaged or missing. The float valve might also be obstructed by the lid-locking mechanism, or there could be no heat in the inner pot. In addition, the inner pot base may be damaged. If there is too little liquid, add thin, water-based liquid to the inner pot according to its size. For other issues, contact Customer Care.
How to fix difficulty closing the lid of my Instant Electric Pressure Cooker?
If you're finding it hard to close the lid of your Instant Electric Pressure Cooker, there are a few things you can check. First, make sure the sealing ring is properly installed and snug behind the sealing ring rack. If the float valve is in the popped-up position, gently press it downward with a long utensil. Lastly, if the contents are still hot, lower the lid slowly to allow heat to dissipate.
General| Model | Instant POT PRO PLUS |
|---|---|
| Capacity | 6 Quarts |
| Voltage | 120V |
| Warranty | 1-Year Limited Warranty |
| Functions | Pressure Cook, Slow Cook, Sauté, Steam, Yogurt, Sterilize, Warm |
| Control | Touchscreen, App Control |
| Material | Stainless Steel |
| Safety Features | Overheat Protection, Safety Lid Lock |
| Smart Features | App Control |
| Wattage | 1200 Watts |
| Pressure Levels | High and Low |
| Type | Multi-functional pressure cooker |
To Next Page
