EasyManua.ls Logo

insys icom EBW-E100 - Page 24

insys icom EBW-E100
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Function Overview
EBW-E100
24
Dynamic DSL connection set-up
A DSL (PPPoE) connection can be established independently if
required. The connection will be terminated again after a configurable
idle time or after a configurable maximum connection time.
Dialling filters for DSL connection set-up
The dialling filters allow to define, which data packets lead to a PPPoE
connection set-up. This helps to avoid needless connections and save
costs.
NAT and port forwarding
The router can also forward data packets via NAT and port
forwarding. According to defined rules, incoming IP packets to
definable ports and port ranges will be forwarded to IP addresses and
ports in the LAN.
IP forwarding
IP forwarding rules can be used to create additional IP addresses at
the LAN ext interface. Packets to one of these IP addresses will be
forwarded to the IP address in the local LAN that is assigned to it.
OpenVPN
The router can be used as OpenVPN server or client. This enables
machines to establish a safe connection to the LAN behind the router
from the outside via an unsafe network. An entire LAN can also be
connected interception-proof and interference-proof via an unsafe
Internet connection through a VPN tunnel to another network (e.g.
the company network). The authentication when connecting to an
OpenVPN server via a static key, a certificate with user name and
password, or just a certificate is supported with this. An OpenVPN
connection without authentication can also be established.
PPTP
The router can be used as PPTP server or client. This enables
machines to establish a safe connection to the LAN behind the router
from the outside via an unsafe network. An entire LAN can also be
connected interception-proof and interference-proof via an unsafe
Internet connection through a VPN tunnel to another network (e.g.
the company network).
IPsec protocol
Two subnets can be connected with each other via an unsafe Internet
connection tap- and interference-proof using an IPsec tunnel. The
authentication when connecting to an IPsec terminal device via
certificates or a passphrase (PSK) is supported with this. Up to
10 tunnels can be established at the same time.
GRE tunnel
GRE tunnel enable a transparent data transmission through an
existing connection without changing the original packets.

Table of Contents