After the completed update, a page is displayed which confirms the
successful update procedure. Do not perform any action at the web
interface until this page is displayed.
An update of the file "data_<rev>" is not always necessary. You'll find
further information about this in the PDF file contained in the firmware
package.
5. In order to update the file "data_<rev>" also, proceed with the second
file "data_<rev>" as with the first file, without performing a restart
before. Repeat the steps from step 1. An automatic restart takes place
following the upload.
6. If you have only uploaded the file "system_<rev>", change in the
"System" menu to the "Reset" page, select "Reset" and click on OK .
The new firmware is now active.
12.6.7 Uploading the Configuration File
You may upload a previously downloaded or edited configuration file to the EBW-
E100, to replace the current configuration by the settings in the file.
Uploading the Configuration File
You have a configuration file for your version of the EBW-E100.
1. In the web interface under "System", switch to the page "Update".
2. Click on Browse... in the "Manual update" section and select the
configuration file (e.g. configuration.bin).
3. Click on OK to start the upload.
A page with a security query is displayed.
4. Confirm the query with Yes .
The upload process of the configuration starts.
After the completed upload, a page is displayed which confirms the
successful update procedure.
5. In the menu "System", switch to the page "Reset", select "Reset" and
click on OK.
The new configuration is now active.
To Next Page
Loading...