12.1.7 Configuring Command Line Interface CLI Access
Besides the configuration via the web-interface or configuration file, a EBW-E100
can also be configured via a CLI (Command Line Interface). It will be protected
against unauthorised access by requesting user name and password (alternatively
also via a Radius server). Access to the CLI can either be accomplished from the
local network or remote via Telnet or SSH. You can specify the port, under which
the CLI can be accessed for Telnet and SSH. You can also configure the CLI
prompt.
A detailed description of the configuration via CLI can be found in the respective
add-on manual.
Configuration via web interface (menu "Basic Settings", page "CLI")
For a local authentication at the device, select the radio button
"Authentication with password" and enter the access data into the
respective fields.
For an authentication at the Radius server, select the radio button
"Authentication at Radius server“.
The Radius server must be configured for this (in the "Basic Settings"
menu on the "Radius" page).
In order to specify the access options (local or remote via Telnet or SSH)
that are permitted for the configuration, check or uncheck the respective
checkboxes.
You can enable or disable the permissible configuration using the
respective checkbox.
If none of these checkboxes is enabled, the CLI cannot be accessed!
You can specify the Telnet port in the "Telnet port" entry field. Port 23 is
set by default.
You can specify the SSH port in the "SSH port" entry field. Port 22 is set
by default.
You can specify the prompt in the "CLI prompt" entry field. "> " is set by
default.
Save your settings by clicking "OK".
To Next Page
Loading...