12.1.6 Configuring Access Protection via Radius Server
The access to the web interface or command line interface (CLI) can be protected
against unauthorised access using an optional Radius server in the network. The
access data for the Radius server must be configured in the EBW-E100 for this.
Configuration via web interface (menu "Basic Settings", page "Radius")
In order to configure access protection via a Radius server, enter its
address and port into the respective fields. Port 1812 is set by default.
Enter also the "Shared Secret" (authentication key) into the respective
field.
These settings are only effective, if the authentication at the Radius
server is selected in the menu "Basic Settings" on the page "Web
interface" and/or the page "CLI".
Save your settings by clicking "OK".
To Next Page
Loading...