12.1.5 Configuring MAC Filter
A MAC filter can be enabled in the EBW-E100. This will then only accept packets at
the local Ethernet interface that come from network devices that are explicitly
permitted in the filter.
This is only effective for connections that are initiated by the device in
the local LAN, not for connections that are initiated from the WAN
side.
If the MAC address of the computer that is used for
configuration is not entered, no further configuration will
be possible any more.
It is necessary that you enter the MAC address of the
computer that is used for configuration into the list of
allowed source MAC addresses before activating the MAC
filter.
Configuration via web interface (menu "Basic Settings", page "MAC filter")
In order to enable the MAC filter, check the checkbox "Activate MAC
filter".
In order to enter a new source MAC address, enter this into the "Allow
new source MAC" field. The MAC address can be entered with or
without colons; other formats are not supported. Save the entry by
clicking "OK".
In order to delete an existing MAC address, check under "Allowed source
MAC addresses" the checkbox of the route(s) to be deleted.
Save your settings by clicking "OK".
To Next Page
Loading...