12.2.3 Configuring Leased Line Operation
You can configure the EBW-E100 to permanently maintain the previously
configured DSL connection. The connection will immediately be established the
connection after system start in this operating mode. The device checks the
connection for its function periodically. The connection check can be performed
either via a DNS request of a host name or via PING at a host.
Configuration via web interface (menu "LAN (ext)", page "DSL")
In order to configure a leased line, check the checkbox "Connect
immediately and hold connection".
If necessary, enter another time in minutes for the connection check into
the entry field "Interval for checking connection". The default setting is 5
minutes. If a closed connection is determined after this time, the EBW-
E100 will attempt to re-establish the connection after one minute. If the
attempt fails, there will be another attempt after 5 minutes. The next
attempt will take place after 30 minutes; if this attempt fails as well, the
device will attempt to re-establish the connection every 60 minutes.
Select the method for connection check using the radio buttons behind
"Type to check the connection" and enter a host name or an "IP
address". If the checkbox "Renegotiate PPP connection in case of failure"
is checked, a failed ping or DNS request causes that a possibly existing
connection will be closed. It will be attempted to establish a connection
again afterwards in any case.
Save your settings by clicking "OK".
To Next Page
Loading...