9 Assembly
This section describes how to mount the EBW-E100 to a DIN rail, connect the
power supply and uninstall it again. Observe the instructions in the "Safety"
section of this manual, in particular the "Safety Instructions for Electrical
Installation" for that purpose unconditionally.
Moisture and liquids from the environment may seep into
the interior of the device!
Fire hazard and damage of the product.
The device must not be used in wet or damp
environments, or in the direct vicinity of water. Install the
device at a dry location, protected from water spray.
Disconnect the power supply before you perform any work
on a device which may have been in contact with
moisture.
The device could be destroyed if the wrong power supply
is used!
If the device is operated with a power supply that supplies
a voltage exceeding the permissible operating voltage, it
will be destroyed.
Make sure that you use the suitable power supply. Refer to
the Technical Data section for the proper voltage range.
To Next Page
Loading...