Integra DRX-3.2 User Manual

123
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Device - Displays the name of the BLUETOOTH-enabled
device connected to the unit.
• The name is not displayed when "Status" is
"Ready" and "Pairing".
Status - Displays the status of the BLUETOOTH-enabled
device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
• Wait for a while if "Bluetooth" cannot be selected. It can be selected when the
BLUETOOTH function is activated.
 4. Power Management
Change the settings for the power-save function.
Setting Item Default Value Setting Details
Sleep Timer O󰀨 You can allow the unit to enter standby
automatically when the specied time elapses.
Select a value from "30 minutes", "60 minutes" and
"90 minutes".
"O󰀨": The unit does not automatically enter standby
mode.
Auto Standby O󰀨 This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled,
the unit enters the Hybrid Standby mode which
minimizes the increase in power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"O󰀨": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit’s
display and TV screen 30 seconds before
entering standby mode.
• "Auto Standby" does not work when Zone 2/
Zone 3 is active.
Setting Item Default Value Setting Details
Auto Standby in
HDMI Standby
Through
O󰀨 Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting is enabled.
"O󰀨": The setting is disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "O󰀨".
USB Power Out
at Standby
O󰀨 When this function is set to "On", electricity can be
supplied to the device connected to the USB port
even if this unit is in standby mode .
• While using this function, power consumption
increases in standby mode, however, the
increase in power consumption is minimized by
automatically entering the Hybrid Standby mode
where only the essential circuits are operating.
Network Standby On When this function is set to "On", you can turn
on the power of the unit via network using an
application such as Integra Remote that can control
this unit.
• When "Network Standby" is used, power
consumption increases in standby mode,
however, the increase in power consumption is
minimized by automatically entering the Hybrid
Standby mode where only the essential circuits
are operating.
• When connection to the network is lost, "Network
Standby" may be disabled to reduce power
consumption. In such a case, turn the unit on by
using the power button on the remote controller
or main unit.

Integra DRX-3.2 Specifications

General

Brand	Integra
Model	DRX-3.2
Category	Stereo Receiver
Language	English