10
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Front Panel≫ Rear Panel≫ Remote≫
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
2. TUNER AM/FM terminal: Connect the supplied antennas.
3. COMPONENT VIDEO IN jacks: Input AV component video signals with a
component video cable. (Compatible only with 480i or 576i resolution.)
4. USB port: Connect a USB storage device to play music les. ( p82) You
can also supply power (5 V/1 A) to USB devices with a USB cable.
5. ETHERNET port: Connect to the network with a LAN cable.
6. VIDEO IN jacks: Input AV component video signals with an analog video cable.
7. RS-232C port: Connect a home control system equipped with an RS-232C
port. For adopting a home control system, contact the specialized stores.
8. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
9. HDMI IN jacks: Transmit video signals and audio signals with an HDMI cable
connected to an AV component.
10.
12V 1A INPUT jack / ON/OFF switch: Used for connection with the HDBaseT
Receiver. Refer to the Instruction Manual included with the HDBaseT Receiver
for usage instructions.
11.
HDBaseT™ IN/OUT jack: Input signals are output via the LAN cable. As they
are covered with a seal when shipped, remove it when you use the ports. Do
not use the ports to connect the ETHERNET port of network device.
12.
RS232 port: Used for connection with the HDBaseT Receiver. Refer to the
Instruction Manual included with the HDBaseT Receiver for usage instructions.
13.
IR IN/OUT jacks: Used for connection with the HDBaseT Receiver. Refer
to the Instruction Manual included with the HDBaseT Receiver for usage
instructions.
14.
AC INLET: Connect the supplied power cord.
15.
GND terminal: Connect the ground wire of the turntable.
16.
AUDIO IN jacks: Input TV or AV component audio signals with an analog audio
cable.
17.
IR IN A/B, IR OUT jacks: Connect a remote control receiver unit.( p71)
18.
12V TRIGGER OUT A/B/C jack: Connect a device equipped with a 12V trigger
input jack to enable power link operation between the device and this unit.
( p72)
19.
PRE OUT jacks: Connect a power amplier. ( p57)
20.
SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The same
signal is output from each SUBWOOFER PRE OUT jack.
21.
ZONE 3 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplier or a power amplier in a separate
room (ZONE 3).
HEIGHT 2 PRE OUT jacks: Connect a power amplier. ( p57)
22.
ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplier or a power amplier in a separate
room (ZONE 2).
23.
SPEAKERS terminals: Connect speakers with speaker cables. (North
American models are compatible with banana plugs.)
To Next Page
Loading...
