68
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting a Pre-main Amplier (ZONE 3)
You can enjoy 2-ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog audio cable
to connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of
the pre-main amplier or power amplier in the separate room. The same source
can be played back in the main room and ZONE 3 simultaneously. Also, dierent
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 3, use
an analog audio cable for connection. Note that ZONE 3 output is not possible
with the connection using a HDMI cable, digital coaxial cable, or digital optical
cable.
Setup
• The ZONE 3 PRE/LINE OUT terminal can output only when "2. Speaker" -
"Conguration" in the Setup menu ( p129) is set to one of the following.
– When "Speaker Channels" is set to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– When "Speaker Channels" is set to "5.1 ch" or "5.1.2 ch", and "Zone
Speaker" is set to "Zone 2/Zone 3"
– When "Speaker Channels" is set to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or
"5.1.2 ch", and "Bi-Amp" and "Zone Speaker" is set to "No"
a
a
LINE
IN
BD/DVD
Premain Amp.
a Analog audio cable
To Next Page
Loading...
Need help?
General
