En-12
Connecting the Receiver—Continued
On the receiver, the factory default for speaker impedance is “6 Ω ”. If you need to change the speaker impedance
setting, read “Speaker Connection Precautions” on page 10 carefully before performing the procedure below.
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
1
Press the [] button to turn on the power.
2
Press the [Setup] button on the remote
controller.
3
Use the arrow []/[] buttons to select
“6. Hardware Setup,” and then press
[Enter].
4
Change the impedance value to “4 Ω” using
the arrow []/[] buttons.
5
Press the [Setup] button on the remote
controller to complete the setting.
If you want to change the impedance setting back
to the factory default setting of 6
Ω, follow the
same procedure described above.
Notes:
• This procedure can also be performed on the receiver
by using [Setup], Tuning []/[], Preset []/[],
and [Enter].
• Press [Return] to return to the previous menu.
Setting example :
If you’re using only one of the speaker sets connected to
SPEAKERS A or B, choose the 4 Ω setting if each
speaker’s impedance is 4
Ω to less than 6 Ω, or choose
the 6
Ω setting if each speaker’s impedance is 6 Ω or
more.
If you’re using both of the speaker sets connected to
SPEAKERS A and B, choose the 4 Ω setting if each
speaker’s impedance is 8 to 16
Ω.
Configuring the Speaker Impedance
To Next Page
Loading...
Need help?
General
