Integra Luxtec MLX 300 - Repair And Return Information; Warranty Service and Repair; Limited Express Warranty; Disposal of the Product, Packing Material, and Accessories

To Next Page

To Previous Page

Repair And Return Information

Disposal of the Product, Packing Material, and Accessories

Limited Express Warranty

This device must be clean and decontaminated prior to return to Integra. Integra reserves the right to return unrepaired any

equipment that is contaminated with blood or other organic material.

Warranty Service and Repair:

To obtain service under warranty or return product for repair, the customer should contact your local Integra representative or

call Integra Customer Service at 1-800-431-1123 or +1-914-789-7094.

For disposal, observe the relevant regulations and laws valid in your country and utilizing regulations of the hospital and

observing any local regulations. For further information, please contact Integra.

Integra warrants that the new MLX light source shall be free from defects in material and workmanship under normal use

and service for a period of three (3) years from the date of shipment. Integra’s sole and exclusive liability under the warranty

shall be, at Integra’s option, either to repair any component which fails during the warranty period due to any defect in

workmanship or material F.O.B. factory if:

1. Customer promptly reports such defect to Integra in writing,

2. If requested by Integra, customer returns equipment to Integra with shipping charges, and

3. Upon inspection, Integra ﬁnds the equipment to be defective.

This warranty is contingent upon normal and proper use of the equipment. It does not cover equipment that has been

modiﬁed with non-Integra parts without the wrien approval of Integra, subjected to unusual physical or electrical stress, or

damaged during shipment. This warranty is non-transferable unless authorized in writing by Integra.

Integra reserves the right to make design changes on its products without liability to incorporate said changes in Integra

products previously designed or sold.

Upon receipt of the product, it should be carefully inspected. If any defect is discovered, notiﬁcation must be given

immediately to the manufacturer or authorized distributor.