Intek KT-370EE - Getting Started

Getting Started - Menu Operation
English
GETTING STARTED
Power ON
Switch on the transceiver turning the Power/Volume knob (3) clockwise until you hear a click, the
transceiver now is in stand-by mode.
Volume adjustment
To adjust the volume, turn the volume knob (3) while using the MONITOR key (13) to listen to the
background noise of the channels.
Channel/frequency selection
Select the desired channel by using the UP/DOWN (8) keys.
Transmission
In order to transmit, press the PTT (11) key and speak with your normal voice, keeping the microphone
at about 4 cm from your mouth. The LED indicator (2) will light in red color. Release the PTT key (11) at
the end of transmission.
Receiving
Release the PTT (11) keyand properly adjusting volume, you will be able to receive the incoming signals.
When receiving a signal, the LED indicator (2) will light in green colour.
MENU OPERATION
In stand-by status, press FUN (7) key to enter the menu. Press the UP/DOWN (8) keys to choose menu
items. After finished setup, press FUN (7) key to return to previous menu (except SCAN, FREQ, T->R,
LED). Press the FUN (7) key again to return to stand-by status.
1. Channel Mode / Frequency Mode
CHANNEL MODE
Press the UP/DOWN (8) keys to choose desired channel.
SCAN ---> T->R (reverse frequency) ---> FREQ (switch to frequency mode) ---> KEYBO (choose
keyboard lock mode) ---> LED (indicator setup) ---> BEEP (warning sound switch setup) ---> POW (RF
output power HI/LOW) ---> SQL (voice level setup) ---> TOT (emission timing setup) ---> VOX (VOX
sensitivity setup) ---> STEP (channel spacing setup) ---> N-W (Narrow-Wide channel spacing setup).
FREQUENCY MODE
Press the numeric keypad (7) to input frequency, and if the input frequency exceeds the allowed range,
it will return to the default value. According to the input number, the Two-Way Radio automatically
calculate frequency step.
SCAN ---> CT/DCS ---> CHANL (switch to channel mode) ---> KEYBO (choose keyboard lock mode) --->
LED (indicator setup) ---> BEEP (warning sound switch setup) ---> POW (RF output power HI/LOW) --->
SQL (voice level setup) ---> TOT (emission timing setup) ---> VOX (VOX sensitivity setup) --->
STEP (channel spacing setup) ---> N-W (Narrow-Wide channel spacing setup).
2. Key Function in the Menu Mode
FUN Key (7) : enter the menu set-up status
CONFIRMATION key (5) : selects and confirms the menu selection
UP/DOWN Keys (8) : choose items
- 10 -