39
the system will boot up if there’s an incoming call from the modem.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled,
you cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.
PM Timer Reload Event
In this item users can either select Enabled or Disabled to enable or disable Primary IDE 0;
Primary IDE 1;Secondary IDE 0; Secondary IDE 1; FDD, COM, LPT Port or PCI
PIRQ(A-D).
PCI Express PME Function
Press Enter to either set Enabled or Disabled the PCI Express PM Function.
3-9 PnP/PCI Configuration
Phoenix – AwardBIOS CMOS Setup Utility
PnP/PCI Configuration
Item Help
IRQ Resources Press Enter
PCI/ VGA Palette Snoop Disabled
**********PCI Express Relative Items*********
Maximum Payload Size 128
Menu Level >
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
PCI/VGA Palette Snoop
This item is designed to overcome problems that can be caused by some non-standard VGA
cards. This board includes a built-in VGA system that does not require palette snooping so
you must leave this item disabled.
IRQ Resources
Names the interrupt request (IRQ) line assigned to the USB on your system. Activity of the
selected IRQ always awakens the system.
To Next Page
Loading...
Need help?
General
