32
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
The optional settings are: [Disabled]; [Enabled].
Port 60/64 Emulation
Use item to enable I/O port 60h/64h emulation support. This should be enabled for
the complete USB keyboard legacy support for the non-USB aware OSes.
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and Time-outs:
USB Transfer Time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device Reset Time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device Power-up Delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller.
The optional settings: [Auto]; [Manual].
‘Auto’ uses default value: for a root port it is 100 ms, for a hub port the delay is
taken from hub descriptor.
Select [Manual] you can set value for the following sub-item: ‘Device Power-up
Delay in Seconds’.
Device Power-up Delay in Seconds
The delay range is from [1] to [40] seconds, in one second increments.
► Intel (R) I210 Gigabit Network Connection (XX:XX:XX:XX:XX:XX)/…
These items show current RJ-45 network brief information.
► Intel (R) Ethernet Connection X553 10 GbE SFP+ (XX:XX:XX:XX:XX:XX)/…
These items show current SPF+ network brief information.
To Next Page
Loading...
Need help?
General
