Intel FALCON 8+ - Page 14

QUICK START GUIDE – Rev. 06 July 2017 QUICK START GUIDE – Rev. 06 July 2017
14
The functional elements of the Intel Cockpit Controller are:
B1 (Button1): Sets the camera to predened angles +/-90°,
+/-45° and 0° (see "Setting the Camera Angle" section below for
details)
B2 (Button2): Changes the function depending on the
connected payload, position 1 = LED OFF, position 2 = LED ON
B3 (Button3): Trigger button
R1 (Rocker-Switch1): Camera tilt
R2 (Rocker-Switch 2): Changes the function depending on the
camera used
S2: Turning the right control stick (S2) controls the yaw axis of
the UAV
Status Display: Additional camera options can be accessed
from the Status Display
ESC, LEFT, RIGHT, ENT: Status Display control buttons (left to
right in Figure 26).
1
2
3
4
5
6
7
8
Camera Controls via the Intel Cockpit Controller
Figure 26
Figure 27
4
1
2
5
67
3
Setting the Camera Angle
Sony Alpha 7R*
The main screen of the Status Display shows the camera angle. 0° means the camera is looking straight forward and is levelled
horizontally. -90° means the camera is looking down, 90° means it is looking up.
Push the Rocker-Switch R1 away from you to tilt the camera downwards. Pull the Rocker-Switch R1 towards you to tilt the camera
upwards. The further R1 is pulled, or pushed, the faster is the tilt movement.
When the camera is not at 0°, a single push of button B1 will set it back to 0°. When the camera is at 0°, pushing and holding B1
and simultaneously pushing R1 shortly, will set the camera to -45°; another short push of R1, while holding B1, will set it to -90°.
When pulling R1, while holding B1, the camera can be tilted upwards accordingly in 45° increments.
The Sony Alpha 7R* has two main function dials that can be controlled through the Intel Cockpit Controller:
The default functions of Dial 1 and 2 depend on the selected shooting mode on the camera:
The function of Dial 1 on the Sony A7R can be controlled by R2,
when B2 is in position 1 (LED OFF).
The function of Dial 2 can be controlled by R2, when B2 is in
position 2 (LED ON/Blue) or via the Status Display by pushing
ENT > Camera Options > Dial 2.
The table below shows the default functions of Dial 1 and 2
depending on the selected shooting mode.
Dial 1
Dial 2
B2 Position R2 Function CAMERA SHOOTING MODE
S Mode (Shutter
Priority)
A Mode (Aperture
Priority)
M Mode (Manual)
1 (LED o) Dial 1 Shutter Speed Aperture Aperture
2 (LED on/Blue) Dial 2 Exposure
Compensation
Exposure
Compensation
Shutter Speed
8