Intel H110

27
C states
Use this item to enable or disable CPU Power Management.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], it allows CPU to go to C states when it’s not 100%
utilized.
Package C State Limit
Use this item to select the Maximum Package C State Limit Setting.
The optional settings: [C0/C1]; [C2]; [C3]; [C6]; [C7]; [C7S]; [C8]; [C9]; [C10];
[CPU Default]; [Auto].
[CPU Default]: Leaves to Factory default value.
[Auto]: Initializes to deepest available Package C State Limit.
 SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
Use this item to enable or disable SATA Device.
The optional settings: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
The default setting is: [AHCI].
SATA1/SATA2
Software Preserve
Port
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable each SATA port.
Hot Plug
The optional settings: [Disabled]; [Enabled].
mSATA/M.2
Software Preserve
Port
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable each SATA port.