27
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbsp]; [RS232=1Mbsp,
RS422/RS485=10Mbsp].
COM5 Port Configuration/ COM6 Port Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Third Super I/O Configuration
* ‘Third Super I/O Configuration’ is only optional for Model NLH61 & NLB75
series.
COM7 Port Configuration/ COM8 Port Configuration/ COM9 Port
Configuration/ COM10 Port Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Voltage Configuration
DIMM Voltage
The optional settings are: [1.60V]; [1.65V]; [1.70V]; [1.75V].
WatchDog Configuration
WatchDog Timer Control
Use this item to enable or disable WatchDog Timer Control. When set as
[Enabled], the following sub-items shall appear:
WatchDog Timer Value
User can set a value in the range of [4] to [255].
WatchDog Timer Unit
The optional settings are: [Second]; [Minute].
Shutdown Temperature Configuration
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [60C/140F]; [65C/149F]; [70C/158F];
[75C/167F].
CPU PPM Configuration
To Next Page
Loading...
Need help?
General
