Intel I350-T4 User Manual

Property Definition
"1", install the base drivers (default).
NOTE: BD should only be set to 0 if the Base Drivers have already been installed prior
to running DxSetup.exe
DMIX "0", do not install Intel PROSet.
"1", install Intel PROSet (default). The DMIX property requires BD=1.
ANS "0", do not install ANS.
"1", install ANS (default). The ANS property requires DMIX=1.
FCOE "0", do not install Fibre Channel Over Ethernet (FCoE) using DCB (default).
"1", install FCoE using DCB. The FCOE property requires DMIX=1.
ISCSI "0", do not install iSCSI using DCB (default).
"1", install ISCSI using DCB. The ISCSI property requires DMIX=1.
POWERSHELL "0", do not install the IntelNetCmdlets module (default).
"1", install the IntelNetCmdlets module. The POWERSHELL property requires
DMIX=1.
SNMP "0", do not install the SNMP Agent (default).
"1", install the SNMP Agent. The SNMP property requires BD=1.
FORCE "0", check that the installed device supports a feature (FCOE, iSCSI) and only
install the feature if such a device is found (default).
"1", install the specified features regardless of the presence of supporting devices.

Intel I350-T4 Specifications

General

Data Rate Per Port	1 Gbps
Controller	Intel I350
Supported Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Operating Temperature	0°C to 55°C
Teaming Support	Yes
Quality of Service (QoS)	Yes
Wake-on-LAN (WoL)	Yes
Product Name	Intel I350-T4
Category	Network Adapters
Ports	4
Bus Type	PCI Express 2.1
Form Factor	Low Profile
Power Consumption	4.4 W
Operating Systems Supported	Windows, Linux, FreeBSD
Jumbo Frames	Up to 9.5 KB
Virtualization Support	Yes