Datasheet 89
Features
6 Features
6.1 Power-On Configuration Options
Several configuration options can be configured by hardware. The processor samples
the hardware configuration at reset, on the active-to-inactive transition of RESET#. For
specifications on these options, refer to Table 6 -1.
The sampled information configures the processor for subsequent operation. These
configuration options cannot be changed except by another reset. All resets reconfigure
the processor; for configuration purposes, the processor does not distinguish between
a "warm" reset and a "power-on" reset.
NOTE:
1. Asserting this signal during RESET# will select the corresponding option.
2. Address signals not identified in this table as configuration options should not be asserted
during RESET#.
3. Disabling of any of the cores within a processor must be handled by configuring the
EXT_CONFIG Model Specific Register (MSR). This MSR allows for the disabling of a single
core per die within the processor package.
6.2 Clock Control and Low Power States
The processor allows the use of AutoHALT and Stop-Grant states to reduce power
consumption by stopping the clock to internal sections of the processor, depending on
each particular state. See Figure 6-1 for a visual representation of the processor low
power states.
Table 6-1. Power-On Configuration Option Signals
Configuration Option Signal
1,2
Output tristate SMI#
Execute BIST A3#
Disable dynamic bus parking A25#
Symmetric agent arbitration ID BR0#
RESERVED A[24:4]#, A[35:26]#
To Next Page
Loading...
