Datasheet 95
Boxed Processor Specifications
7 Boxed Processor Specifications
7.1 Introduction
The Intel Core™2 Extreme processor QX9650, Intel Core™2 quad-core processor
Q9000, Q9000S, Q8000, and Q8000S series will also be offered as an Intel boxed
processor. Intel boxed processors are intended for system integrators who build
systems from baseboards and standard components. The boxed processor will be
supplied with a cooling solution. This chapter documents baseboard and system
requirements for the cooling solution that will be supplied with the boxed processor.
This chapter is particularly important for OEMs that manufacture baseboards for
system integrators.
Note: The Intel Core™2 Extreme processor QX9770 requires a special liquid cooling thermal
solution. It will not be offered with the processor. Refer to the appropriate Thermal and
Mechanical Design Guidelines (see Section 1.2) for further guidance.
Note: Unless otherwise noted, all figures in this chapter are dimensioned in millimeters and
inches [in brackets]. Figure 7-1 shows a mechanical representation of a boxed
processor.
Note: Drawings in this section reflect only the specifications on the Intel boxed processor
product. These dimensions should not be used as a generic keep-out zone for all
cooling solutions. It is the system designers’ responsibility to consider their proprietary
cooling solution when designing to the required keep-out zone on their system
platforms and chassis. Refer to the appropriate Thermal and Mechanical Design
Guidelines (See Section 1.2) for further guidance. Contact your local Intel Sales
Representative for this document.
NOTE: The airflow of the fan heatsink is into the center and out of the sides of the fan heatsink.
Figure 7-1. Mechanical Representation of the Boxed Processor
To Next Page
Loading...
